FLEX support for the VAG Group expands even further. With version 8.13.0.0, it is now possible to program the Bosch MG1CS111 ECU, equipped with a TriCore TC298 processor.

Thanks to Boot Glitch unlocking, it is possible to work on the ECU completely independently, including in Bench mode, without the need to ship it Magicmotorsport laboratories.

A solution that simplifies the workflow and ensures full control over the entire operation.

The new support is available to all customers with a Flex Full Master (FLS0.5M) or Flex Full Slave (FLS0.5S) license.

Key insights

VAG Bosch MG1CS111 TC298

• Working Mode: Boot Glitch — Bench
• Memories: Read/Write/Checksum Internal Flash, Read/Write Internal EEPROM, Full Backup, Boot Unlock
• Licenses: FLS0.5M/S
• Connect/Glitch Time: ~ 5 minutes
• Reading Time: ~ 2 minutes and 30 seconds
• Writing Time: ~ 2 minutes

Some of the supported vehicles

• Audi A3 (III) 8V (2012MY) 2.0L TSI [CZPB] 187HP
• Cupra Formentor (I) (2020MY) 2.0L TSI [DKZA] 188HP
• Skoda Octavia (IV) NX (2020MY) 2.0L TSI 16v [DRFA] 187HP
• Volkswagen (VW) Arteon (I) 3H (2017MY) 2.0L TSI [CZPB] 187HP
• Volkswagen (VW) T-Roc (I) A1 (2017MY) 2.0L TSI [CZPB] 187HP

FLEX Master
FLEX Slave