MD Flasher is professional software for working with odometers as well as with immobilizers, airbags and ECUs. The software is module based and is protected with a USB dongle. It requires a J2534 adapter. It has been tested with the following adapters Dialink and Scanmatik.

System requirements

• Windows 10 or higher
• Intel Core i5 or equivalent processor
• 8 GB RAM
• 5 GB available hard drive space

Technical support is porvided by the developer directly.

After you receive the dongle, the modules must be activated within a month. Please be attentive and contact us in time for activation.

Attention! In case of the dongle loss, the module transfer is not possible. You have to buy a dongle and software again.

Please note the modules cannot be deactivated. If you provide the wrong dongle number, no refund will be possible. Also if you happen to buy a module you already have, no refund will be possible. Please be attentive.

MD Flasher is professional software for working with odometers as well as with immobilizers, airbags and ECUs. The software is module based and is protected with a USB dongle. It requires a J2534 adapter. It has been tested with the following adapters Chipsoft J2534 Lite & K-line, Chipsoft J2534 Mid & K-line.

The full version includes:

• M&D Flasher USB dongle;
• ALL the software licenses on the moment of purchase, you can find the list here; 

Adapter for working with microcontrollers using the M&D Flasher

The board has the following pins VDD, FV, PWR, A1, A2, GND, RST, MD0, MD1TX, RX, RTX. Voltage levels of 3.3V and 5V are supported (selected by jumpers on the board).

Currently supported with:

1. License 109 — VW Polo 6RF(U)92086x BENCH/OBDII
2. License 139 — UAZ 9S12HY64 DASH BDM
3. License 140 — Lada Largus 2021+ ABS UART
4. License 149
5. License 22 (software 3.0 and above)
6. License 55 - MCU Renesas RH850 R7F701xxx
7. License 59 - MCU Renesas V850
8. License 150 NEC78K0 UAZ UART