Adapter for working with microcontrollers using the M&D Flasher
The board has the following pins VDD, FV, PWR, A1, A2, GND, RST, MD0, MD1TX, RX, RTX. Voltage levels of 3.3V and 5V are supported (selected by jumpers on the board).
Currently supported with:
M&D Flasher
MD Flasher is professional software for working with odometers as well as with immobilizers, airbags and ECUs. The software is module based and is protected with a USB dongle. It requires a J2534 adapter. It has been tested with the following adapters Dialink and Scanmatik.
System requirements
Technical support is porvided by the developer directly.
After you receive the dongle, the modules must be activated within a month. Please be attentive and contact us in time for activation.
Attention! In case of the dongle loss, the module transfer is not possible. You have to buy a dongle and software again.
Please note the modules cannot be deactivated. If you provide the wrong dongle number, no refund will be possible. Also if you happen to buy a module you already have, no refund will be possible. Please be attentive.
